Web Console, Telnet Console, Serial Console, Windows Utility ICMP, IPv4, TCP, UDP, DHCP, BOOTP, Telnet, DNS, SNMP V1, HTTP, SMTP, SNTP, Rtelnet, ARP, RFC2217 The NPort® 5600’s LEDs not only indicate current system and network status, but also help field engineers monitor the status of attached serial devices. The System LED, Serial Tx/Rx LEDs, and Ethernet LEDs (located on the RJ45 connector) provide a great tool for basic maintenance tasks and help engineers analyze problems in the field. LED Indicators to Ease Your Maintenance Tasks Since no set of resistor values is universally compatible with all environments, NPort® 5600-8-DTL device servers use DIP switches to allow users to adjust termination and pull high/low resistor values manually for each serial port. When using termination resistors, it is also important to set the pull high/low resistors correctly so that the electrical signal is not corrupted. In some critical environments, termination resistors may be needed to prevent the reflection of serial signals. The NPort® 5650-8-DTL device servers support selectable 1 KÙ and 150 KÙ pull high/low resistors and a 120 Ù terminator. You can both centralize management of your serial devices and distribute management hosts over the network.The NPort® 5600-8-DTL device servers have a smaller form factor than our 19-inch models, making them a great choice for applications needing additional serial ports when mounting rails are not available.Ĭonvenient Design for RS-485 Applications NPort® 5600-8-DTL device servers can conveniently and transparently connect 8 serial devices to an Ethernet network, allowing you to network your existing serial devices with basic configurations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |